The carpet cleaning machine is an unmatched machine in the carpet cleaning industry.
The machine itself has 2 vacuum motors 46101 - VACUUM MOTOR 2ST that may be switched on individually depending on the requirement for suction power.
Furthermore the machine also has a water pump that is used for pumping water from the machine to the tools that will be used by the operator.
The machine comes with accessories as well. Among this is:
1 × Floortool
1 × Handtool
2 × Lids
Specifications:
Capacity
Clean Water Tank: 35L
Dirty Water Tank: 42L
Vacuum Motors
Quantity: 2 Motors
Stages: 2 Stage
Max Power: 2500 W
Air Flow: 60 l/s
Vacuum: 35 kPa
Water Pump
Power: 180 W
Pressure: 60 PSI
Delivery Rate: 2.6 l/min
Suction Hose
The 5m black suction hose has a diameter of 38mm with two cuffs, one attached to either end.
The 5m blue pipe has the H8C and a QR(P) attached the either end of the pipe.
The fittings are held together by two small clamps.
The black hose and blue pipe are connected by cable ties.
Lids
The lids are made op Perspex with the length of about 20cm, width of about 15.4cm and height of 0.8cm.
A cap is attached in the middle of the Perspex.
Rubber is glued underneath the Perspex to seal completely. The height of the lid with the rubber is about 1.5cm.
It is recommended to use the Low Foam Powder with the machine as it is a tried and tested product for cleaning and also does not create a lot of foam, which is desirable for carpet cleaning.