Huanix Repair kits Injection rail for VALTEK SET A Set of four originals~17584 Mechanical Fuel Pump

VALTEK INJECTION PLATE REPAIR KIT 4 pcs. This is an original Italian set of parts provided by the manufacturer of the injection rail, intended for its regeneration. This allows it to be improved without replacing it with a new one. The finished kit allows you to regenerate one section of VALTEK type 30 injectors (1Ω, 2Ω, 3Ω), old type RAIL (1Ω, 2Ω, 3Ω), RAIL IG1 Apache. The kit includes: stem with rubber valve 4 pcs spring 4 pcs rubber sealing ring 4 pcs The most common problem that arises during the operation of the previously mentioned types of strips is a malfunction of the strip injection system, which causes the so-called "nozzle spill". The cause of such a defect is usually oleate contamination or wear, which leads to the destruction of the rubber elements of the strip. One of the most common signs of wear of the slats is: idling power loss at idle increased gas consumption problems when adjusting the system Then the simplest and est solution is to regenerate it using the appropriate repair kit. The kit includes the slats (photo 3): Valtek type 30 Approval number: E4 67R-010104 The Valtek type 30 injector is one of the most popular gas injectors. There are three versions of the coil resistance: the most popular 3Ω with red coils, 2Ω with gray coils and 1Ω with yellow coils. At the same time, it also looks like a version with four, three, two or one injection part. -------------------------------------------------- -------------- Old type IG1 rail approval number: E8 67R-014303 RAIL The IG1 injector is the equivalent of the most popular Valtek injector, unlike the Valtek strips, it had black or blue coils on 3 Ω models, on 1 Ω models the coils were yellow, also on Valtek models. It often had a silver body instead of black.