Sonoff mart Wifi Gate Motor / Garage Motor / Electric Fence Energizer Control Add-on Module | Sonoff Smart Switch  (Green)

Smart Wifi Gate Motor / Garage Motor / Electric Fence Energizer / Alarm Panel Control Add-on Module | Sonoff Adding this Smart Wifi Module to any Garage door motor / Electric Gate Motor or Electric fencing energizer will take you less than 15 minutes. Enable your old legacy devices to be wifi-controlled from your phone with an app on your smartphone. Forgot to close the garage door or gate at home when you left ? Or your remote is not working ? No problem, control it from your phone from anywhere to operate it to the required state. The wireless module supports inching /self-locking mode. You can add the device to the eWeLink APP on Android and Apple Smartphones to remote control connected home appliances or devices. In self-locking mode, you can remotely turn on/off connected devices immediately. When in inching mode, you can turn on the switch for 0.5s and then auto-turn-off after another 0.5s. This simulates the press of the remote control button thereby opening or closing your gate or garage motor. Setup Instructions to Pair with Ewelink App: Download Ewelink app from Playstore or Apple Store on your smartphone Power the Smart Wifi Module (Easier to pair before Installation) with either a Micro-USB Cable from a 5v Charger or any USB Port or power it via 2 wires on the DC 7v-32V Connectors as per below diagram with a 12v battery or 12 volt power source. Long press the model change button as per below picture for more than 5 seconds until the blue LED starts Blinking fast 2 times and slow for 2 sec. Open Ewelink App and Click Add-Device. Please ensure if your access point is on 5Ghz that there is a 2.4Ghz Wifi to connect to since the devices works via 2.4Ghz Wifi’s only. This can be changed on your router if a problem connecting to your wifi network. If device is not discovered via Add-Device on Ewelink please click on Bluetooth Pairing and check device discovered and add it to Wifi Network by selecting the wifi network name and inputting the password for the wifi network to connect to. Features: Two working voltage: USB 5V and DC 7V-32V This device supports Normally Opened (NO) or Normally closed (NC) switching. With signal instruction LED light and relay pull-on instruction light Power < 1W, and quiescent current:80mA Cutover current< 10A , Cutover voltage< 250V 10A Relay Model Maximum pull-on time: 15mS Maximum release time: 5mS Working Temperature: -40 to 70degree Working Humidity: 40% to 80% RH Size: about 80*15*35mm